[Staemius]

I'll be wiring up a 212 with JBL's soon - series wiring. From the jack to the first speaker will I splice the in and out wires and plug these into the spring loaded posts? (Since there is no output posts?) - thanks!

[TI4-1009]

Remember with JBLs "black is red and red is black" !?

[Staemius]

So, what's under the tape? - assuming you stripped the "1" wires before the input and then wrapped and taped wires going to speaker 2? thanks.

[TI4-1009]

yup. no magic.

[Smolder]

series is just a loop. connect a black terminal on speaker one to the red term on speaker two. the remaining black goes to the tip, and the red to the barrel of the cabinet's jack.

[TI4-1009]

smolder is correct- my photo shows parallel wiring- two 8 ohm JBLs wired to create a 4 ohm load. If you loop wired them (series) you would get a 16 ohm load.

[Staemius]

Thanks guys - was really just unclear about best way to connect the jack wires to wires from speaker 1 (I meant to say parallel wiring) - since the JBL's do not have an output pole. Got it now - thanks again!