here's the loaded cab...K120 (original) in the bottom & K120 (e120 recone) top .
Those are the wires from the voice coil that connect to the terminals on the frame. THey are delicate and the bedding in glue protects them and heals the holes in the cone which they pass through.vwjodyme wrote:since you just reconed maybe you know the answer to my dumb question, what are those 2 drip marks on all speakers? i figure it has to serve a purpose since if it was just from over gluing someone would have figured out how to clean it up by now.
You are correct, that is not parallel. And, Yes, you are drawing 8 ohms if each speaker is 8 ohms.eric wrote:So something just occurs to me .. I dont think I'm running in parallel .. I have each side of my SS power amp running to its own single speaker.. So that would mean I'm actually creating an 8 ohm load at the amp.. Is this right? Am I that thick that I was running 8 ohms the whole time? Which actually might have been a good thing , seeming the power rating of my amp vs speaker power rating..