Page 1 of 1
PreSonus Tube PreAmp
PostPosted:Tue Dec 11, 2007 9:23 am
by mutant_dan
I am wondering if anyone has tried the ProSonus Tube preamp?
I have seen some really nice DIY tube preamps but would rather not have to warm up the soldering iron.
PostPosted:Tue Dec 11, 2007 10:31 am
by strumminsix
I used one in a quest to warm up a POD XT modeler.
What I got was slight improvement with:
warmth, natural compression, level control to the amp
PostPosted:Wed Dec 12, 2007 9:48 am
by Revv23
Howw do these work in application? Do you just plug it into the power section of your amp?
PostPosted:Wed Dec 12, 2007 3:22 pm
by mutant_dan
Revv23 wrote:Howw do these work in application? Do you just plug it into the power section of your amp?
My plan is to run into a tube pre and plug the output directly into a solid state rack mounted power amp.
PostPosted:Tue Mar 04, 2008 9:35 am
by mikepand
I use one for my Weir rig and have had no problems until recently. One side blew out. Probably just the tube. I have gotten quite a few gigs out of it and overall it sounds clean and really boosted my overall volume. They are not exspensive either.