Grateful Dead Music Forum

I am looking for info on the value of the tone resistors and pots in alligator - I tried following a link to a schematic in one of the threads but it led to a dead end anyone have any basic info they could share? It looks like from other threads that one of the tone pots was wired to control the neck and bridge and the other to control the middle PU - sounds like a cool thing to try while I’m in there any info would be greatly appreciated - thanks much

I used a dual pot for the tone control for the neck and bridge pickups.

Bill, tgo

Would that be better than putting a jumper between the 2 leads on the switch.

I don’t know, but my info is that Alligator had a dual pot.

Bill, tgo

Oh cool - thanks much - that is very helpful a 250k pot?
Do you happen to know the resistor values?

"If the Alligator wiring ye seek,
To the Waldo trove must ye then treek.."

https://waldotronics.forumotion.com/t13 ... nash-strat

The tone capacitor was a mylar film type, the value was .1uF. Best bet, use one made by Cornell Dublier.

They're coming out of the woodwork....

And 9852 days since last Dark Star.

Bill, tgo

TI4-1009 wrote: ↑Sat Mar 20, 2021 10:56 am They're coming out of the woodwork....

Don't talk about woodworking or cabinets, it will get you banned.