Page 1 of 1
Help with Carvin DCM200 L Setup
PostPosted:Tue May 22, 2018 11:22 am
by Atk1
I just got one of these. I have a 2x12 cab wired in parallel for 4ohm. I can't figure out the bridge and impedance switches. How should they be set? The manual isn't particularly clear to me:
Should I rewire the speakers for 16ohm?
Thanks
Re: Help with Carvin DCM200 L Setup
PostPosted:Tue May 22, 2018 11:40 am
by mkaufman
Looks like if you press the button, you'll get 100W output.
ace
Re: Help with Carvin DCM200 L Setup
PostPosted:Tue May 22, 2018 11:51 am
by Atk1
good lord that makes sense to me now..
thank you
Re: Help with Carvin DCM200 L Setup
PostPosted:Tue May 22, 2018 2:11 pm
by Erbis
I would play around with the buttons and A,B,C,D the perceived power at the same setting on a guitar plugged into the system...dont change any settings on the pre or the guitar and then push the buttons and see how the cab behaves and I bet it's easy to understand what is what