Page 1 of 1

OK - 50 watt 12" speaker? Best for e120 clone? Tone Tubby?

PostPosted:Wed Dec 14, 2011 8:32 am
by jmfranc
I have a Blues Jr and need a new speaker but one that's within range of the output of my amp. So, I need a 50 watt speaker that sounds similar to a JBl e120. Before I buy - is Tone Tubby Red the way to go? I have a Tiger clone and going for the late 80's Jerry tone. Downhill From Here sound.

Re: OK - 50 watt 12" speaker? Best for e120 clone? Tone Tubb

PostPosted:Wed Dec 14, 2011 11:54 am
by zambiland
I wouldn't worry about matching the ratings. Your amp will have no trouble driving an E120 (or K or Weber or Eminence version or whatever). In fact, the speaker will last a lot longer and JBLs are noted for efficiency, so you'll get more out of your amp. The only way you don't want to go is to get a speaker that's rated lower than your amp. The reason those ratings exists is to determine how likely it is to blow up the speaker. If the speaker is rated lower than the amp, the answer is pretty likely, if it's rated higher, then the question becomes do you like the tone of that speaker? If yes, then choose that speaker.

Re: OK - 50 watt 12" speaker? Best for e120 clone? Tone Tubb

PostPosted:Wed Dec 14, 2011 12:21 pm
by FretfulDave
I am no expert on this stuff but the Blues Jr is a 15 watt tube amp. Not sure why a 50 watt speaker is needed there. Any 25 watter should do. It is the sound you want but I also thought if you got a speaker that was rated for too high a wattage relative to what your amp puts out, it won't drive efficiently and thus might not give the sound you would expect, i.e. using an e120 in a little studio type amp.

Dave

Re: OK - 50 watt 12" speaker? Best for e120 clone? Tone Tubb

PostPosted:Wed Dec 14, 2011 1:37 pm
by jmfranc
FretfulDave - I was asking about a speaker that might sound like a k or d120 but a 50 watt version. I will never need 300 watt handling ability. It needs to be 12". The Fender stock is 12" and handles 50 watts.