Page 1 of 1
Rocktron 300 with a 1x12
PostPosted:Fri Jul 15, 2011 8:00 am
by Bobbyg
For light traveling, can I use my 1x12 (JBl K-120) 8 Ohm speaker cab powered by the Rocktron Velocity 300 amp. Would I be in danger of blowing the speaker?
Re: Rocktron 300 with a 1x12
PostPosted:Fri Jul 15, 2011 8:44 am
by hippieguy1954
Bobbyg wrote:For light traveling, can I use my 1x12 (JBl K-120) 8 Ohm speaker cab powered by the Rocktron Velocity 300 amp. Would I be in danger of blowing the speaker?
The K-120 is rated for 100 watts.
Re: Rocktron 300 with a 1x12
PostPosted:Fri Jul 15, 2011 8:49 am
by Bobbyg
Since it is 100 Watts, does that mean I can't run it with the Rocktron?
Re: Rocktron 300 with a 1x12
PostPosted:Fri Jul 15, 2011 8:55 am
by strumminsix
I'd question if the Rocktron is okay with only using 1 side.
Re: Rocktron 300 with a 1x12
PostPosted:Fri Jul 15, 2011 9:39 am
by strummingturtle
I have done this with good results. switch mode to "bridged" and use channel 1. I have only played in small places like this so the amp did not make it past 1/2 cranked.
Call Rocktron to check they are nice folks 269-968-3351
Peace
Re: Rocktron 300 with a 1x12
PostPosted:Fri Jul 15, 2011 10:17 am
by JamminJommy
SS amps only hit their wattage rating with the throttle open. Theoretically, you are not in danger of blowing the speaker if you keep it lower than 2/3 on the dial by running only one side. I think...
Peace,
Jommy
Re: Rocktron 300 with a 1x12
PostPosted:Fri Jul 15, 2011 1:29 pm
by zambiland
JamminJommy wrote:SS amps only hit their wattage rating with the throttle open. Theoretically, you are not in danger of blowing the speaker if you keep it lower than 2/3 on the dial by running only one side. I think...
Peace,
Jommy
This is not entirely true. You can get a solid state amp to put out its entire power rating with the input down by feeding it enough gain. It might distort first, which would make it even more likely to blow your speaker from sending it a signal that is clipping.
As far as using one channel, this shouldn't harm the amp. If it does, the Rocktron is a piece of crap. However, from what people have said, it's not, so this isn't a problem.
As far as blowing the speaker, just keep your ears open for signs of stress and if it seems like you are over loading the speaker, simply turn it down.
Short answer: go for it.
Re: Rocktron 300 with a 1x12
PostPosted:Fri Jul 15, 2011 1:38 pm
by Bobbyg
Thanks for the tips and your thoughts. I have this nice original K120 and really don't want to ruin it! I suppose I will just keep the volume down, probably only need it on 3 or 4 anyway.
Re: Rocktron 300 with a 1x12
PostPosted:Fri Jul 15, 2011 1:41 pm
by mijknahs
eeeeee wrote:As far as blowing the speaker, just keep your ears open for signs of stress and if it seems like you are over loading the speaker, simply turn it down.
But they sound sooo good right before they blow...
Just kidding. I've never blown a speaker before.
Re: Rocktron 300 with a 1x12
PostPosted:Fri Jul 15, 2011 1:56 pm
by Bobbyg
mijknahs wrote:eeeeee wrote:As far as blowing the speaker, just keep your ears open for signs of stress and if it seems like you are over loading the speaker, simply turn it down.
But they sound sooo good right before they blow...
Just kidding. I've never blown a speaker before.
I was afraid of that!
