[lbpesq]

I don’t believe that one has an AC outlet, which the OP needs to run the Tru-Tron. When I had my big board, I used the Cioks Ciokolate which had an AC output that could be adjusted for voltage.

Bill, tgo

[strumminsix]

I used the Cioks Ciokolate

Yup, here's what I'm running:
https://www.sweetwater.com/store/detail ... wer-supply

This is why I suggested a page back to understand your power needs. Everyone shouting advice. I've had 9v, 10v, 12v, 18v, DC, AC, center pos, center neg... Gotta know what your pedals need or it's foolish and expense venture into power supplies...

[walterbriggs]

Another thing to consider. Since my new Quilter Aviator Mach 3 allows me to turn the effects loop on/off with a foot-switch, I’ve been experimenting with moving some of my pedals into the effects loop.

Bill, tgo

Would you share the settings you’re using on the Mach 3 for Jerrytones?

[lbpesq]

Not really going for Jerry tones. I’m the “Bobby” in my Dead band. In my non-Dead band I take some leads, but I’m not going for Jerry. I basically set channel 1 for my preferred rhythm sound using one of the Fender voices, and set the second channel for lead, using either the Plexi or the Dumble “Sweet” voice.

Bill, tgo

[Jon S.]

I'm building a 2nd pedalboard to leave in California as, when I'm there, jams happen.

Below are pics of my main board and 2nd-board-in-progress. Both are intended to support everything from my original music to Dead to a wide range of other cover music.

[Jon S.]

I've already gotten a compliment on my special limited edition "Sticky Yellow" Micro-Tron IV.

[Jon S.]

My new-for-my-CA-2nd-residence pedalboard is done! I just tested it and everything works perfectly.