Hi
I've taken the plunge. I'll be running an SMS preamp into the Carvin, then into a single JBL E-120.
Is it OK to use just one channel, or is that bad for the amp? I assume it's ok to just use one channel but thought I'd check. That would be a bit more flexible of a setup, as I do have a 2nd speaker I could add.
As per specs, the JBL can handle the bridged power of that amp (300>200w) and I doubt I would need to turn it up too high. Better to just bridge it? The JBL has the original cone and I'd prefer not to damage it.
Any words of advice on this, or any other tips to get the best tone with this setup?
Thanks!
Mark
I've taken the plunge. I'll be running an SMS preamp into the Carvin, then into a single JBL E-120.
Is it OK to use just one channel, or is that bad for the amp? I assume it's ok to just use one channel but thought I'd check. That would be a bit more flexible of a setup, as I do have a 2nd speaker I could add.
As per specs, the JBL can handle the bridged power of that amp (300>200w) and I doubt I would need to turn it up too high. Better to just bridge it? The JBL has the original cone and I'd prefer not to damage it.
Any words of advice on this, or any other tips to get the best tone with this setup?
Thanks!
Mark