I have a new cab with a E110 installed. The speaker is held in with it's own screws, but I grabbed some HT style clips to dress it up a little. My question is, why does the speaker clips have a small ledge on the bottom? Why is it not flat to be flush with the cab? What is the reason for the 3 steps? I'll try to post a photo.
At this point, the clips are only holding on a thin speaker grill, and not the actual speaker. So there is not really any real weight on them. I'm just curious why these are designed this way.
At this point, the clips are only holding on a thin speaker grill, and not the actual speaker. So there is not really any real weight on them. I'm just curious why these are designed this way.
Once in a while you get shown the light
In the strangest of places if you look at it right.
In the strangest of places if you look at it right.