[ShinyAntelope]

I recently acquired 1 Super 2 and 1 Super D and would like to install them in my PRS S2 Standard 24 which has 1 volume, 1 Tone, and 1 push pull to split both coil at once.

Do they have a wiring diagram that I should use or is it going to be different with the PRS wiring?

Thanks for any help you can give.

[PurpleTrails]

I didn't see one that was on the money on the dimarzio site.

Assuming you have one of the PRS with a blade switch, try this one:

https://guitarelectronics.com/2-humbuck ... -coil-tap/

You'll have to use the color code for dimarzio to figure out which wire does what on the pups, but the diagram should work.

The dimarzio site has pretty limited options. The seymour duncan site is much more complete, but the color of the wiring doesn't line up with dimarzio. The guitar electronics one has even more options.

[ShinyAntelope]

Thanks PurpleTrails, that is it exactly. I will identify and label the leads and then go from there.

I am going to orient the coils that are split toward the inside to hopefully get closer to Jerry's tone and then consider adding and sds-1 if needed next.