Sell and buy at your own risk...
 #166533  by milobender
 Fri Nov 29, 2019 10:27 am
Modified Alembic type bridge, milled using bar stock, typical TOM stud spacing, stainless screws, brass nut, chrome stud/thumb wheel, each saddle hand seated to the bridge floor... everything can be changed, stud spacing (pre-order), black screws, stainless nuts, locking studs (pre-order for custom studs), etc... this one is finished to a worn out 800 grit, antiqued, and polished finish will add to the cost, and nickel plating on top of that (the brass has to be polished before nickel plating anyway), the same.

Pricing is: $160 for the bridge with 800 grit satin finish, plus $20 for the studs on this one, $180 total plus shipping

For antiquing add $20, for polished brass add $30; for nickel plating an additional $30 on top of the polishing (the brass must be polished before plating)

No extra charge for different screws or nuts
. For an additional fee I can round off the nuts so they are cylindrical, instead of hexagonal, if desired.

Image
Image
Image
Image
Image
Jblue76, NeilG1, ChinaCatMatt and 1 others liked this