Chat about Equipment Info
 #136160  by Jon S.
 Tue Jan 28, 2014 6:07 pm
Few pedals can handle it. But what makest y'all of the Pigtronix Class A Boost?
A preamp that delivers up to 20db of clean boost for both instrument and line level signals.

The Pigtronix Class A Boost Guitar Effects Pedal will fatten up and boost anything you feed it. The deceptively simple design uses discreet transistors in a single-ended “Class A” configuration to achieve the warmest possible tone. This remarkable preamp can deliver up to 20db of clean boost and remains effective with both instrument and line level signals.

Superior signal to noise performance allows you to put the Class A Boost anywhere in your pedal chain. It can add punch and extra output to a classic overdrive sound and is able to push distortion pedals into extremely aggressive crunch land. Class A Boost is also ideal for hitting the front end of a tube amp to achieve an added layer of sweetness and fat tone.

This pedal runs fine on 9 volts but ships with an 18 volt adapter for superior headroom and maximum punch. Make your sound 1 louder with this handsomely dressed, J-FET masterpiece from Pigtronix.
 #136168  by waldo041
 Tue Jan 28, 2014 7:10 pm
hippieguy1954 wrote:Brad warns about that here:
forum/viewtopic.php?f=419&t=12919&hilit ... 30#p130295
thanks for the clarification! probably will edit my post to stifle an confusion.

 #136169  by waldo041
 Tue Jan 28, 2014 7:24 pm
hippieguy1954 wrote:Seems like a good boost. Why would you run it (or anything else) between the pre and power amp? I'm intrigued.
The idea behind this is to raise the output level of the preamp to saturate the input of the amplifier, just as you would with the boost in front of the preamp. An issue when done before the power amp is once you clip the input of the amplifier the output of the amplifier is going to be amplifying only that clipped signal and it may or may not be what you are after. The Jerry type clipping most are after is to get the output transistors to clip on their own.

 #136170  by hippieguy1954
 Tue Jan 28, 2014 7:39 pm
I'd like to further mod my McIntosh to clip easier at lower volume, if possible. I have done the mod to take the sentry monitor out of the circuit. That seems to make a slightly improved difference in how loud it has to be before clipping at high volumes.
I'm now trying to find out what the next step would be to accomplish this! Then we could "clip it", maN! :smile:
 #136173  by Smolder
 Tue Jan 28, 2014 8:18 pm
So... thinking 'out of the box'... if it were a tube amp, you could do a mismatch on the speaker output. An 8 ohm load on a four ohm tap would drop the overall volume by about 30% and allow you to drive the amp hotter. Not sure if that same effect would translate to an ss mac.
 #136178  by Jon S.
 Wed Jan 29, 2014 4:07 am
It's always good to have more options and tools at our disposal. Depending on the preamp and power amp (some but far from all of us have McI's), boosting the instrument signal into the preamp may sound better or worse to us (or be more or less easy or practical) than boosting the line level out of the preamp into the power amp or modding the power amp.