I just got a real 65 twin and would like to try and run it through my mc2300. On the schematic it says 1.vibrato preamp out and 2. normal preamp out. My question is, do I tap both or pick one? The schematic shows two additional 1/4 in outs that were put into the amp right? Could I get the same results by using the rca out where the vibrato pedal would go?
Just trying to make some sense of this and go the easiest route without doing any permanent mods to my amp. It looks fairly simple but please correct me if I am wrong!
Just trying to make some sense of this and go the easiest route without doing any permanent mods to my amp. It looks fairly simple but please correct me if I am wrong!