The placement of the mic is super important. About an inch or so from the cones center right off the dust cap. Then, tilt the mic aiming Down a little to catch some more tone from the farther section of the middle of the cone. Kind of like mixing both in the final signal. that seems to work well for me and was taken from a picture of Jerry's cabs. It seems like I am trying to catch both highs and mids/low mids with the right tilt. I will try to take a pic. Just putting it right at the center of the speaker hasn't givens a tone I like best.
http://otislotus.net/ Finally finished our new site...