just wire one pair of speaker cables to each speaker and combine the positive (positive to positive)and negative(negative to negative) ends together on the amp side. that is parallel wiring, if the speakers are 8 ohms each parallel wiring will make it a 4 ohm output when you combine the speaker cables together at the amp side. sometime the speaker cab will have a single output jack, this may be your case. if so, just do the same and combine the positives and negatives at that single jack. and then use a speaker cable from that jack to the amps jack.
i doubt you will do series but if you need it, use 2 speaker cables and wire the positive of one speaker to the positive of the other speaker and the negative to the negative of the other speaker in the same manner. now wire a second speaker cable to one of those speakers, does not matter which. the speaker you wired with the second speaker cable will actually have 2 sets of wires in each terminal. the other end will go to the amp. with 2 - 8 ohm speaker this will give you a 16 ohm output.
Disclaimer: I get paid to make, modify or build things for those that seek what i may be able to provide.