If you go that route (using the vibrato RCA jack) you MUST pull all the power tubes from your Fender amp. Otherwise you will ruin your output transformer.Jerry1996x wrote:Ok. So basically, i will have 1 RCA cord running out of the input i have the tap modded to, straight to the mac? Im going to email a tech. I will send him a link to Waldos sight and tell him to look under Post Alembic Preamp Tap. I dont mind dropping the vibrato, and I want as little noise as possible. So when this is all done, what will I need to use it? Just a normal RCA cord?
Yes, just a normal RCA cable (single / mono) from the Fender to the McIntosh. Then conncet your speakers to the McIntosh with the appropriate ohm load.
Also, some of the Post-Alembic tap won't work if you use the vibrato RCA jack. The Post-Alembic tap requires the use of a 1/4" stereo jack in order to shunt the power section when you use the preamp tap.