Here is the response I got directly from the RockTron support Tech: Jim Chowning Technical Support 800-388-4447 jim@rocktron.com
Question:
Subject: Velocity 300:
Hi,
Can I use the Velocity 300 to run a mono pre-amp signal to Channel-A only, and plug two 8ohm speakers into the Channel-A outputs in UN-bridged mode (with nothing going to Channel B)?
Then if I need more power, switch to Bridged mode?
Thx,
pete b.
Answer:
Hi Peter;
We do not recommend running the amp at 4 ohms in bridged mode. I would just recommend running each channel separately even if you had to use a Y cord to plug the same mono single output into both amp channel inputs for max power.
Jim
My response:
You can't run two 8ohm speakers in parallel in Bridged mode?!?!?... You're fuckin' fired!
Question:
Subject: Velocity 300:
Hi,
Can I use the Velocity 300 to run a mono pre-amp signal to Channel-A only, and plug two 8ohm speakers into the Channel-A outputs in UN-bridged mode (with nothing going to Channel B)?
Then if I need more power, switch to Bridged mode?
Thx,
pete b.
Answer:
Hi Peter;
We do not recommend running the amp at 4 ohms in bridged mode. I would just recommend running each channel separately even if you had to use a Y cord to plug the same mono single output into both amp channel inputs for max power.
Jim
My response:
You can't run two 8ohm speakers in parallel in Bridged mode?!?!?... You're fuckin' fired!