schmidtz wrote:I'm in the Twin Cities.
Savage hasn't quoted me yet.
If you say you have good mods, by all means, do tell!!
I thought tantalum was bad....
schmidtz wrote:-ALL stock Potentiometers swapped out for ALLEN BRADLEY MIL SPEC TYPE J/ RV4 type
RiverRat wrote:schmidtz wrote:-ALL stock Potentiometers swapped out for ALLEN BRADLEY MIL SPEC TYPE J/ RV4 type
Skip the milspec pots and you'll shave about $100 off.
I have a Bill of Materials with part numbers for Newark.com if you're interested.
schmidtz wrote:Unfortunately, Savage hadn't even looked at it after three weeks, so I decided to skip it and try myself.
I settled on just replacing the coupling and power caps. I also lifted the legs on my vibrato to stop the ticking.
This does bring up another point, however. I have the MC250 and I want to preamp the twin. Could I just run a wire from the preamp spot on the tag board and tie it into the positive node on my vibrato RCA?
The other thing I can think of is actually removing the vibrato's white wire, solder in the red preamp wire in, and use the existing negative wire.
Return to Jerry Tone
Users browsing this forum: No registered users and 5 guests