The McIntosh Sentry Monitor
Although the autoformer provided an efficient match between the power transistor output and a variety of load impedances, a short circuit at the amplifier output or a load that was much lower than the selected autoformer tap could cause excessive current to flow in the output transistors. To complement the new transistor amplifiers, the McIntosh Sentry Monitor circuit was developed which prevented destructive current levels from occurring under any conditions. This circuit sensed the dynamic operating time, voltage and current of each amplifier output stage and controlled the current flow, confining it to non-destructive limits. The arrangement assured complete circuit reliability for all load conditions. The Sentry Monitor did not limit the rated power output available from the amplifier in any way. McIntosh power amplifiers continue to use the Sentry Monitor circuitry.
Return to Jerry Tone
Users browsing this forum: tcsned and 9 guests