Schematic for switchable buffer?

Schematic for switchable buffer?

Postby jackevorkian » Tue Dec 25, 2012 7:49 pm

Is there a schematic floating around for Tiger wiring, but has the buffer as switchable? I've modded a Gibson 336 with a Super II, buffer and OBEL...the tapped middle position Super II with the buffer sounds perfect...but I kind of miss having the classic Gibson neck and bridge sounds - the buffer seems to alter it a bit. Rather than rewire everything again to just have the buffer on the Super II, I think it might be easier to just make the buffer switchable.
Posts: 159
Joined: Wed Mar 03, 2010 8:08 pm

Re: Schematic for switchable buffer?

Postby mgbills » Wed Dec 26, 2012 8:56 am

I tried to figure this one out. You could put a DP/DT toggle between the output of the 5 position switch and the input of the volume pot. The other leg would send the signal to the buffer.

However, when you remove the buffer you're sending your pickups to a 25K Log pot direct. This puts a strangle-hold on your tone. I can't speak to whether or not the 25k log pot can be substituted, but I suspect it would be another trade off. You'd get the direct to p/u line functioning, and lose the great functionality of the OBEL.

There are smarter folks than I here. That's what my futzing about has shown.

"Hi Ho...the Carrion Crow...FoldeRoldeRiddle"
User avatar
Senior Member
Posts: 1039
Joined: Thu Apr 29, 2010 12:04 pm
Location: The Northwest Corner

Return to Jerry Tone

Who is online

Users browsing this forum: TI4-1009 and 6 guests