So, I ordered up some Mogami cable and Neutrik plugs to rewire my pedal board. I'm experienced with general soldering, but haven't had to do a bunch of cables before. The iron I currently have is 25W. Will that be adequate for the job, or is it recommended to use one with more power? I don't want to end up with cold solder joints.
I was a lot happier after I moved up from a 25w to a 45w. A lot more heat- you can get in and out a lot faster, particularly for soldering grounds onto pots. For cables and jacks you might be OK with the 25.
"Do not write so that you can be understood, write so that you cannot be misunderstood." -Epictetus