Ok, I have a question.
Right now, I run a Boss line selector LS-2 http://www.amptone.com/bossls2.htm
to separate my higher gain distortion channels it has a blend knob for the two loops.
I run TU-Tuner>LS-2 loop 1>Micro Qtron>Octave>ANMAN TS9 Sil>HM-2>CS2Comp>LS-2 Loop 2>GE7 EQ>DD6
I run it so I can blend the clean loop with the drive loop.
So my question is if I get this TPC-1 where would it go? In front of everything to let it power up all of my effects?
and do I essentially have this with the line selector? Im sending a hot signal to my "drive" loop.
Would the TPC-1 keep a consistent signal to all of it?
On a side note: I am experimenting with the compressor after everything but dont think I like it. Would go before everything normally, but thats neither here, nor there, just avoiding effects chain placement comments other than my question.
Information is not knowledge. Knowledge is not wisdom. Wisdom is not beauty. Beauty is not love. Love is not music. Music is the best.- the girl from the bus