Gr8fulGreg wrote:I pulled the power tubes out this morning and have 0 sound when i plug into my power amp to my cab.... I can plug into the pre amp out but there is no reverb.... anyone have another idea? put power tubes back in? idk i dont want to fry my amp but it sounds like crap without reverb
JonnyBoy wrote:Here is a sound clip of our last show, I played my SMS through the HRD III tube power section. Out of the SMS into the effects loop in of the HRD. Notable difference from the MAC's tone, but still, a tube amp sounds pretty damn good tone wise. My bandmates say they like the tone better from the tube amp. I do too, but I hate the envelope filter tone from it and miss the clipping you get from the mac too.
waldo041 wrote:i would tap it at C24, lifting the leg to the Phase Inverter and shunting to ground the pad where you lifted the leg from. also, be sure to remove the speaker plug so the speaker jack also shorts the output section rendering the entire power section dead . you will lose the presence control, but will keep the reverb.
mgbills wrote:JohnnyBoy youz a baddass on that geetar! That you sangin' too? I know you've covered it but what is the name of your band and where you at?
Nevermind...found your website on your signature line. Awesome.
Return to Loudspeakers
Users browsing this forum: No registered users and 3 guests