Jerry1996x wrote:Ok. So basically, i will have 1 RCA cord running out of the input i have the tap modded to, straight to the mac? Im going to email a tech. I will send him a link to Waldos sight and tell him to look under Post Alembic Preamp Tap. I dont mind dropping the vibrato, and I want as little noise as possible. So when this is all done, what will I need to use it? Just a normal RCA cord?
If you go that route (using the vibrato RCA jack) you MUST pull all the power tubes from your Fender amp. Otherwise you will ruin your output transformer.
Yes, just a normal RCA cable (single / mono) from the Fender to the McIntosh. Then conncet your speakers to the McIntosh with the appropriate ohm load.
Also, some of the Post-Alembic tap won't work if you use the vibrato RCA jack. The Post-Alembic tap requires the use of a 1/4" stereo jack in order to shunt the power section when you use the preamp tap.