Now I have everything all wired up according to the diagram below but I have a strange issue I haven't been able to figure out. When I have the DPDT switch in bypass everything works as I would expect and sounds good, with no effects of course. When I engage the loop all of my pedals behave very strange. e.g. my delay pedal sounds as though I have all the knobs maxed out with intense delay and decay, when in fact the dials are set to minimal effect. When I hit the Qtron it screeches as if the signal is way to hot? All of my effects are behaving in a weird way.
I built my own junction box as well according to the other diagram below, but now looking at it again the only difference is I ran two ground wires from the stereo jack with one going to the send and one going to the return instead of daisy chaining as the image shows. Any chance this could cause a problem? I just noticed this so I haven't had a chance to go rewire it yet to see.
Any thoughts or suggestions would be greatly appreciated.
NSP wrote:Yeah, thanks Dave.
Found the diagram that I needed. This forums a great resource, thanks to all for sharing.