Hey guys, I noticed the comments on the fit of my speaker clips. Just wanted to let you know that I can make anything you want but it would be impractical for me to try and supply 'off the shelf' clamps of this sort for every speaker flange/gasket height out there. You might notice that at Waldo's site where I got the official drawing for these to fit the JBL E120 it does say that a piece of leather or some other filler is to be used between the clamping surface and the speaker and it's designed for 1/2" height with no filler according to the drawing. I went out and measured my reconed E120 and it's 5/8". Really high. So maybe there's some variation out there. For esthetic reasons I'd say as close to parallel with the speaker cab baffle would be best. In any event, If you can measure it, I can make it. Don't feel bound to buy off the ebay shelf as it were, just send me a message and I can either make or modify and send them out.
When the secrets all are told,
And the petals all unfold.