Pre amp Tube Replacement Advice
17 posts
• Page 2 of 2 • 1, 2
Re: Pre amp Tube Replacement Advice
by tigerstrat » Mon Oct 31, 2011 3:23 pm
I'm kinda curious as to why a power amp would sport three 12ax7 tubes...
"There, in huge black letters, was 'The Grateful Dead'. It just... cancelled my mind out."-Garcia
-
tigerstrat - Senior Member
- Posts: 4534
- Joined: Wed Nov 30, 2005 1:20 pm
- Location: Portland,OR
Re: Pre amp Tube Replacement Advice
by Cmnaround » Mon Oct 31, 2011 3:48 pm
Yeah, I should have titled the thread Pre- and power amp tube replacement. It has the matched pairs of EL84 power tubes, then a single 12AX7 for the input stage, and one 12AX7 for each phase inverter, A and B sides.
Preamp has no reverb, so only a single 12AX7 for each side, clean and lead, although I'm often using the clean side for lead hehe.
Preamp has no reverb, so only a single 12AX7 for each side, clean and lead, although I'm often using the clean side for lead hehe.
- Cmnaround
- 710 ashbury
- Posts: 258
- Joined: Fri Apr 02, 2010 6:16 pm
- Location: Philadelphia
17 posts
• Page 2 of 2 • 1, 2
Who is online
Users browsing this forum: No registered users and 3 guests