I need to build a cable out of Stereo Belden Blue with a single TRS jack on one end (no problem) and dual mono plugs on the other.
How do I do the dual mono plugs? Specifically what do I do with the shielding/grounding? Split the shielding in half and send half to each mono plug? Do that but also add a jumper wire to connect the two ground plugs? What's the best way?
How do I make a Y cable with Belden Blue?
3 posts
• Page 1 of 1
How do I make a Y cable with Belden Blue?
by Rusty the Scoob » Mon Oct 08, 2012 3:23 pm
-
Rusty the Scoob - Senior Member
- Posts: 2206
- Joined: Mon Mar 03, 2008 5:28 am
- Location: Concord, MA
Re: How do I make a Y cable with Belden Blue?
by jeffm725 » Wed Oct 10, 2012 8:01 am
Dan,
Call me if you need advice....much easier to talk it out than type a manifesto...
Call me if you need advice....much easier to talk it out than type a manifesto...
.......................................................have you heard the one about the yellow dog?
- jeffm725
- Senior Member
- Posts: 1059
- Joined: Mon Jun 09, 2008 1:16 pm
- Location: Chester, CT.
Re: How do I make a Y cable with Belden Blue?
by Rusty the Scoob » Thu Oct 11, 2012 2:13 pm
jeffm725 wrote:Dan,
Call me if you need advice....much easier to talk it out than type a manifesto...
Cool, will do, thanks! I can think of a few different ways, just not sure which is best.
-
Rusty the Scoob - Senior Member
- Posts: 2206
- Joined: Mon Mar 03, 2008 5:28 am
- Location: Concord, MA
3 posts
• Page 1 of 1
Return to Grateful Dead Equipment Discussion
Who is online
Users browsing this forum: Google [Bot] and 3 guests